Bang-olufsen BeoLab 2 - User Guide Manual do Utilizador Página 1

BeoLab 2 Guide

10When Beolab 2 is connected tothe mains, the stand-by indicatorlights up in red, indicating thatBeoLab 2 is in stand-by and readyto be used.BeoLab 2

NOTE: This equipment has been tested andfound to comply with the limits for a class Bdigital device, pursuant to part 15 of the FCCRules. These limits

www.bang-olufsen.com

CAUTION: To reduce the risk ofelectric shock, do not removecover (or back).No User-serviceable partsinside. Refer servicing toqualified service person

3Contents of the GuideBefore you start…4 CautionsNOTE! Read this before you start settingup your BeoLab 2.Connect your speaker system6 Speaker connect

4We recommend that you followthis procedure when setting upthe BeoLab 2 subwoofer:– Read and abide by the cautionson these two pages.– Disconnect your

5OUT OUTPOSITIONCORNERWALLFREE321SETUPINMains cord bracket Mains lead socketPower Link output socketsPower Link input socketPOSITION switch SETUP swit

6You gain access to the BeoLab 2socket panel through the hole onthe rear.For reference, when locating thesockets, use the overview on theprevious page

7Setup examplesDolby Digital system:> Connect one end of the cable to the socketmarked IN on BeoLab 2, and the other endto the socket marked SUBWOO

8BeoLab 2 can be placed almostanywhere in a room. However, themost natural sound and beststereo/surround sound experienceis obtained if BeoLab 2 is se

9Setting the POSITION switchUse the POSITION switch to ensure that thebass response suits the placement ofBeoLab 2, and thus the surroundings.Which sw