Bang-olufsen BeoLab 3 - User Guide Manual do Utilizador

BeoLab 3 Guide

>> Adapt BeoLab 3 to your room Setup examples Here are three examples which show how to set the POSITION switch on each loudspeaker in different

3506393 Version 1.0 1211 This product fulfils the conditions stated in the EEU directives 89/336 and 73/23. Technical specications, features an

www.bang-olufsen.dk

ContentsDaily use Setting up BeoLab 3 Cable connections Adapt BeoLab 3 to your room

Acoustic Lens Technology – manufactured under license from Sausalito Audio Works. To get access to the approval labels, remove the BeoLab 3 top cap. N

Daily use When you have nished setting up the loudspeakers as described on the following pages, connect the entire system to the mains. The loudspeak

Setting up BeoLab 3 We recommend that you follow this procedure: – Disconnect your system from the mains. – Place the loudspeaker according to the g

abc~ 3 m (10')30 cm (12")0150 cm (60")90 cm (35")abc5For optimal sound performance make sure that the loudspeaker is directed towa

Cable connections POSITION switch This switch has three settings: FREE, WALL, and CORNER. Which setting to use is explained in ‘Adapt BeoLab 3 to your

Power LinkMk 3LEFT RIGHT1LEFT RIGHT27Power Link connections: These connections carry both the right and left sound signals. There fore, the cables may

Adapt BeoLab 3 to your room The POSITION switch When a loudspeaker is placed in a corner, the bass level is boosted compared to the bass level from a

FREEWALLCORNER~ 3 m10'~ 3 m10'9How to measure? The distances referred to, are measured as shown here (the loudspeaker seen from above). The